Orbit 67404 Installation Guide download pdf (Page 7)

Dr ip M a s t e r

12 13

DripMaster

Remove the ½" End Cap and turn

on water to flush system; replace cap.

Note: If your Drip-irrigation

system is being installed on non-

level ground, replace all 4 GPH Flag

Drippers with 1 or 2 GPH Pressure

Compensating Drippers to ensure consis-

tent water flow across the entire system.

IMPORTANT: The total number of 4 GPH (Gallons per Hour) Flag

Drippers attached to a single ½" Supply Line should not exceed 45.

Supplies needed:

- Flag Drippers (part # 65201, 66201 or 68201)

- ½" Loop Stake (part # 61442P, 65731or 66731)

- ¼" Insect Plug (part # 66405 or 67405)

- Punch Tool (part # 61285 or 67756)

SECTION

SMALL TREES & SHRUBS

Distribution/Supply Line—Lay the ½" Distribution/Supply Line

next to the base of your plants, shrubs, and trees. Install a ½" End Cap at the

end of the tubing. Use Loop Stakes to hold in place.

Hole Punch—Punch holes on

top of the ½" Distribution/Supply

Line next to the base of each plant,

shrub or tree. Insert the barbed end

of a 4 GPH Flag Dripper into the

hole.

If needed, attach ¼" Distribution/

Supply Line to the end of the Flag

Dripper and run the ¼" Distribution/

Supply Line to the plant location.

Install an insect plug into the end

of the ¼" Distribution/Supply Line.

Common Hose Faucet Projects

Loop Stake

Orbit

DripMaster

| Installation Guide Orbit

DripMaster

| Installation Guide

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

No comments

Orbit 67404 Installation Guide Page 7