This section will show you how to install your sprinkler system.
Marking Head and
Pipe Location
Begin by marking
the entire layout
• Use Orbit
®
sprin-
kler flags to mark
each head.
• Use ground paint to
mark where sprin-
kler pipes will run.
Important:
• Refer to your local code information for any regulations about connecting to the water main.
• Before digging, contact utility companies and have them mark utility lines.
• Obtain permits (if required).
• Always use gloves and safety goggles when installing.
Dig Access Hole
1
.
Dig to expose the
water service line
(downstream from
the meter).
2. Shut off the main
water supply
(located next to
the meter).
3.
Open a faucet to
relieve pressure
in the pipes.
INSTALLATION
Installation
Sprinkler System Layout & Installation Guide
13
1
2
SYSTEM LAYOUT
3
CONNECT TO W
ATER MAIN
Water Meter and Main Shut-Off
Connect Here for
Main Sprinkler Line
Flo
w
Water Service
Line for House
07WTM003045 53251-01 rE.qxd 3/2/07 2:30 PM Page 13
Comments to this Manuals